Cisco TelePresence System Codec C40 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Cisco TelePresence System Codec C40에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence System Codec C40 46 페이지. Telepresence c series telepresence mx series telepresence sx series telepresence ex series
Cisco TelePresence System Codec C40에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (42 페이지), 문제 해결 매뉴얼 (37 페이지), 사용자 설명서 (48 페이지)

페이지 인쇄

Cisco TelePresence System Codec C40 시작하기 매뉴얼

Cisco TelePresence Video Systems

Contents

Configuration tasks (continued)

Setting the H.323 and SIP parameters

(when not set by a provisioning system)

To get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SIP protocol for video calls.

Choose one of the following methods to set the H.323 and

SIP parameters:

Touch controller

Remote control

and on screen menu

Web interface

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

Setting date and time

(when not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among other

things this information is used to time stamp messages trans-

mitted to gatekeepers and other network elements.

Choose one of the following methods to set the date and time:

Touch controller

Remote control

and on screen menu

Web interface

Configuration

Setting the menu password

We strongly recommend that you set a password for the

Administrator Settings menu.

This menu, which is available on both the Touch controller and

the remote control, gives access to settings that affect the

behavior of the video conference system.

Choose one of the following methods to set-up the menu

password:

Getting Started Guide

Appendices

Remote control

and on screen menu

Web interface

Contacts