Cisco TelePresence System Codec C40 시작하기 매뉴얼 - 페이지 17
{카테고리_이름} Cisco TelePresence System Codec C40에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence System Codec C40 46 페이지. Telepresence c series
telepresence mx series
telepresence sx series
telepresence ex series
Cisco TelePresence System Codec C40에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (42 페이지), 문제 해결 매뉴얼 (37 페이지), 사용자 설명서 (48 페이지)
페이지 인쇄
Cisco TelePresence Video Systems
Contents
Configuration using TRC5 remote control and on-screen menu*
Waking up the system
If there is no menu on screen, press
Home
control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been switched
on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If there is still no menu on screen, make sure the monitor cable
is connected to the basic video output connector. If in doubt,
see the installation guide for your product.
* This section does not apply for SX10, SX80, EX Series and MX Series.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction
User interfaces
(
) on the remote
Configuration
Configuration
Remote control and
on-screen menu
17
Getting Started Guide
Appendices
Contacts
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.