Argo Holly 사용 설명서 - 페이지 11
{카테고리_이름} Argo Holly에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Holly 13 페이지.
페이지 인쇄
(3) SLEEP BUTTON (on the remote control and on the control panel)
In cooling mode, press the UP and FAN buttons to activate the Sleep mode, after which the unit will return to
the silent mode and save energy.
N.B.:
The Sleep function is not available in the dehumidifying or fan modes.
(4) DOWN BUTTON
Press this button to adjust the temperature and set the time.
(5) UP BUTTON
(on the remote control and on the control panel)
Press this button to adjust the temperature and set the time.
(6) SPEED BUTTON
In the cooling and fan modes, press this button to adjust the ventilation speed to low (Low) or high (High). In certain
conditions, the fan speed may not function according to the settings.
In dehumidifying mode, this button cannot be pressed, thus the fan will forcefully choose the low fan speed.
(7) TIMER BUTTON (on the remote control and on the control panel)
a. When the air conditioner is off, press "TIMER" to set when to switch the unit on. Press "+" o "–" to set the time, and press
"TIMER" again to confirm.
b. When the air conditioner is on, press "TIMER" to set when to switch the unit off. Press "+" o "–" to set the time, and press
"TIMER" again to confirm.
c. After setting the time, press "TIMER" to cancel the time setting.
(8) FULL TANK
When the tank is full with condensate the LED light turns on and the air conditioner emits a sound for some seconds.
WARNING!
Before carrying out any cleaning or maintenance operations, unplug the appliance.
1. Cleaning the air filters
Filter Frame
Use a vacuum cleaner to remove the dust from the filters. Should this not
suffice, wash the filter with lukewarm water and some neutral detergent
(if necessary), then rinse it thoroughly in cold water and leave it to dry in
air before putting it back in place. Once the filter has been replaced,
close the grille and resume use of the air conditioner.
2. Cleaning the casing.
Use a damp and soft cloth to clean the outer surface of the appliance.
Do not use excessively hot water, solvents, petrol or other aggressive chemical compounds, talcum powder or brushes:
these may damage the surface or colour of the casing.
Remove any stains using lukewarm water with a little neutral detergent.
Do not pour water onto the air conditioner to clean it, as this may damage its internal components or cause a short-circuit.
V 12/17
(on the remote control and on the control panel)
CARE AND MAINTENANCE
Filter
The air filters must be checked at least once
every two weeks of use. Operating the
appliance with dirty or clogged filters will
decrease the air conditioner's efficiency and
may cause serious problems.
To remove the filters, pull the grille's lever.
23