Cisco UC 520 설정 매뉴얼 - 페이지 4
{카테고리_이름} Cisco UC 520에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UC 520 19 페이지. Unified communications 500 series ip pbx setup guide
페이지 인쇄
Cisco Unified Communications 500 Series
2) Launch Configuration Assistant. See the Getting Started with Cisco
Configuration Assistant document at
the CD-ROM that shipped with your product for more information.
a) Factory default username and password are cisco/cisco
3) Using an RJ-45-to-RJ-45 Ethernet cable, connect the Ethernet port of the
PC on which the Cisco Configuration Assistant is installed to a PoE port on
the front panel of the UC 500.
4) Use the Configuration Assistant to perform the following tasks. For more
information, see online help.
a) Connect to a New Community.
b) Accept the default values to create the initial configuration.
Note – If you are installing a single-site key system configuration, change
the "Voice System Type" setting from PBX to Key System Configuration.
c) Save the configuration
5) Confirm that the UC 500 appears in the Topology View.
A.2.
Telephony Setup Wizard
When running Cisco Configuration Assistant for the first time, the Telephony
Setup Wizard will start automatically and guide you through configuring basic
settings on the Cisco UC500
Welcome and Overview
www.cisco.com/go/configassist
or on
Page 4