Argo MAGICO 9.2 AMG26MIR 기술 데이터 및 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Argo MAGICO 9.2 AMG26MIR에 대한 기술 데이터 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo MAGICO 9.2 AMG26MIR 19 페이지.

5-8 Manual Unit Control and LED Indicators

The push button switch and the LED indicators on the front of unit let the user to control the unit operation

without a remote controller. Their operations are provided below.

Led indicators:

STAND BY

OPERATION

TIMER

Push button switches:

OPERATION

BUTTON

Last unit settings (SPT, operation mode, etc) are saved in the EEPROM in the unit.

In case of power failure, these settings are restored automatically.

1. Lights up when the air conditioner is connected to power and is ready

to receive the R/C commands

2. Blinks continuosly in case of any thermistor failure

1. Lights up in operation mode (note: off in stanby mode)

2. Blinks for 0,5 sec to announce that a R/C infrared signal has been received and stored

1. Lights up during Timer and Sleep operation

2. Active on/off timer setting will become invalid after a power failure

When this happens, the unit is forced to restart in STBY mode, and the timer indicator

indicator is blinked continuosly until (i) the unit is switched to OPERATION mode again ,

or (ii) any message from the R/C is received

Use to cycle the operation mode of the A/C unit among COOL and OFF modes,

without using the R/C

Every time this switch is pressed, the next operation mode is selected, in the order:

Off mode => Cool mode => Off mode => Cool mode => .......