Cisco Webex DX80 설치 매뉴얼 - 페이지 3

{카테고리_이름} Cisco Webex DX80에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Webex DX80 6 페이지. Ce 9.5
Cisco Webex DX80에 대해서도 마찬가지입니다: 사용자 설명서 (40 페이지)

Connect Cables

Factory

reset

pinhole

Power

Type B

Service port

1. Place the DX80 face down on a flat, clean, surface with the camera off the edge of

the table. Do not exert force on the camera as this may damage it.

2. Flip the connector cover up to access the connector panel, and lead the cables under

the strain relief bar.

3. Connect the Ethernet cable (A) between the network connector

wall socket.

4. Connect the provided power adapter and cable (B) between the DX80

power socket.

5. Pull the foot stand, set the DX80 in an upright position, and adjust the angle. The foot

stand is stiff to open at first.

To use the same network wall socket for both your computer and DX80, connect your

computer to the computer network port on the DX80, and the DX80 to the network wall

socket (see step 3).

HDMI out

(not in use)

USB

HDMI in

USB

Micro-SD

slot

Computer

Kensington

network

Network

and a network

and a

lock