ACU-RITE 06087 사용 설명서 - 페이지 11

{카테고리_이름} ACU-RITE 06087에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 06087 16 페이지. Professional weather display

페이지 인쇄

Troubleshooting

Problem

No outdoor sensor

reception

no bars

Outdoor

temperature

is flashing or

showing dashes

Inaccurate forecast

Display screen

not working

• Relocate the display and/or the 3-in-1 sensor.

The units must be within 330 ft (100 m) of each other.

• Make sure both units are placed at least 3 feet (.9 m)

away from electronics that may interfere with the wireless

communication (such as TVs, microwaves, computers, etc).

• Use standard alkaline batteries (or lithium batteries

in sensor when temperature is below -4ºF/-20ºC). Do

not use heavy duty or rechargeable batteries. NOTE:

It may take a few minutes for display and sensor to

synchronize after batteries are replaced.

• Synchronize the units:

1. Bring both the sensor and display indoors and

remove batteries/power adapter from each.

2. Reinstall batteries in outdoor sensor.

3. Reinstall batteries/power adapter in display.

4. Let the units sit within a couple feet of each other for

a few minutes to gain a strong connection.

Flashing of the outdoor temperature may be an

indication of wireless interference.

• Make sure the A-B-C switch in the battery

compartments of both the display and sensor are

switched to the same letter. You may choose A, B or

C; but both units must match to sync up. Sometimes

changing to a different channel can help.

• Weather Forecast icon predicts conditions for the next

12 to 24 hours, not current conditions.

• Allow unit to run continuously for 33 days. Battery

removal or resetting the display will restart Learning

Mode. After 14 days, forecast should be fairly

accurate, however Learning Mode calibrates for a

total of 33 days.

• Check that the power adapter is plugged into the

display and an electrical outlet.

• Check that the batteries are installed correctly.

Batteries may need to be replaced.

• Reset the display by pressing and HOLDING the

"RESET" button, located on the back of the display.

Date and time will need to be entered after a reset.

Possible Solution