Cisco 2100 Series 구성 매뉴얼 - 페이지 8

{카테고리_이름} Cisco 2100 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2100 Series 40 페이지. Cisco 8500 series wireless lan controller
Cisco 2100 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (49 페이지), 구성 매뉴얼 (50 페이지), 빠른 시작 매뉴얼 (12 페이지)

페이지 인쇄

Connecting to the Controller Via a Browser

3. Power-on the controller. Status of the controller's boot process will

appear as the controller is powering up. Once the controller is

running, it will prompt you to run the Startup Wizard.

4. The Startup Wizard provides for an easy means to perform initial

controller setup and provisioning. Refer to the Installation and Startup

Guide for the Cisco 4400 Series WLC, or other appropriate controller,

found at Cisco's website. This document contains a detailed

explanation of using the Startup Wizard for the 4400:

http://www.cisco.com/en/US/docs/wireless/controller/4400/quic

k/guide/ctrlv32.html#wp34023

5. Once the controller has been configured via the Startup Wizard, the

remaining configuration can be configured through the switch-web

interface using a Web browser (Cisco recommends using MS IE 6.0+).

6. If necessary, the controller can be reset to factory defaults. To reset

the WLC to factory default, you must reboot, then type

at the CLI. This only works before the first time a user logs in

config

via the console.

1. Connect to the WLC by pointing your internet browser to the URL:

https<IP_Addr> (where <IP_Addr> is the IP address of the

management interface of the WLC).

2. Click the

prompt. The default

admin

3. Once logged in properly, a page similar to the one below displays.

VIEW Certified Configuration Guide

Recover-

and

User Name

Password

PN: 1725-36192-001_H