Argo snappy 사용 설명서 - 페이지 7
{카테고리_이름} Argo snappy에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo snappy 12 페이지. Local air conditioner
페이지 인쇄
3. HEATING MODE
TO USE THE AIR CONDITIONER IN HEATING MODE, DISINSERT THE FLEXIBLE HOSE AND THE CONNECTOR,
ROTATE 180° THE UNIT.
INSERT THE CONNECTOR FOR COLD AIR EXPULSION AND THE FLEXIBLE HOSE ON THE REAR OF THE
APPLIANCE.
Press FUNC
By default, the temperature is set to 25ºC.
The temperature can be adjusted between 15° and 25°C.
In this way, each time the Power button
set and when switched back on again, it will retain this setting.
Fan seed is fixed to the maximum (HI) and cannot be adjusted.
In this way, Timer and SLEEP functions can be set.
This equipment automatically vaporises the condensation in Cooling and Heating mode.
Ensure that when the unit operates as Cooling or Heating, the rubber caps that close the discharge holes on the sides are
correctly positioned.
When the air conditioner works in Cooling and Heating, there is no need to arrange for continuous drainage of condensate;
only in specific weather conditions where air humidity levels are very high may water deposit within the unit. When the
internal tank is full, the control panel displays E4, to warn that it is full and the unit stops working.
V 11/13
to select HEATING. The LED will switch on.
HOW TO ELIMINATE CONDENSATE
is pressed, the unit switches off, the appliance saves the temperature
Cooling and heating
To empty the tank, switch the air conditioner off and unplug
it. Remove the drainage hole cap at the bottom on the right
(frontal view, cooling operation) and connect a little tube
through which drain the condensate; place the other end on
top of a normal reservoir.
Ensure that the tube is not twisted or bent. The tube must
slope downwards. Close the drain again with the cap and
restart using the air conditioner.
Dehumidification
ATTENTION!
When using the air conditioner in Dehumidification mode,
we recommend always ensuring continuous drainage, in
order to guarantee maximum dehumidification efficiency.
To empty the tank, switch the air conditioner off and unplug
it. Remove the drainage hole cap below the grill on the right
side (rear view) and connect a little tube through which
drain the condensate; place the other end on top of a
normal reservoir.
18