ACU-RITE Atlas 06105 사용 설명서 - 페이지 9

{카테고리_이름} ACU-RITE Atlas 06105에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE Atlas 06105 12 페이지. High-definition display

페이지 인쇄

Troubleshooting

Problem

No reception

no bars

Temperature is

showing dashes

Inaccurate forecast

Inaccurate wind

readings

• Relocate the display and/or the AcuRite Atlas

The units must be within 330 ft (100 m) of each other.

• Make sure both units are placed at least 3 ft (.9 m) away from

electronics that may interfere with the wireless communication

(such as TVs, microwaves, computers, etc).

• Use standard alkaline batteries (or lithium batteries in sensor

when temperature is below -4˚F/-20˚C). Do not use heavy

duty or rechargeable batteries.

It may take a few minutes for display and sensor to

NOTE:

synchronize after batteries are replaced.

• Synchronize the units:

1. Bring both the sensor and display indoors and remove

power adapter/batteries from each.

2. Reinstall batteries in outdoor sensor.

3. Reinstall power adapter in display.

4. Let the units sit within a couple feet of each other for a few

minutes to gain a strong connection.

When the outdoor temperature is showing dashes, it may be an

indication of wireless interference between the sensor and display.

• Re-add sensor to display by accessing the "Connections"

sub-menu (see page 7).

• Weather Forecast icon predicts conditions for the next 12 to

24 hours, not current conditions.

• Allow product to run continuously for 33 days. Powering

down or resetting the display will restart Learning Mode. After

14 days, forecast should be fairly accurate, however Learning

Mode calibrates for a total of 33 days.

• What is wind reading being compared to? Pro weather

stations are typically mounted at 30 ft (9 m) or higher. Make

sure to compare data using a sensor positioned at the same

mounting height.

• Check location of the sensor. Ensure it's mounted a minimum

of 5 ft (1.5 m) in the air with no obstructions around it (within

several feet).

• Ensure wind cups are spinning freely. If they hesitate or stop, try

lubricating with graphite powder or spray lubricant.

Possible Solution

sensor.