Cisco 2800 Series 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 2800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2800 Series 13 페이지. Cisco ios software configuration
Cisco 2800 Series에 대해서도 마찬가지입니다: 데이터시트 (8 페이지), 빠른 시작 매뉴얼 (47 페이지), 애플리케이션 노트 (41 페이지), 빠른 시작 매뉴얼 (45 페이지), 구성 (10 페이지), 개요 (27 페이지), 데이터시트 (5 페이지), 데이터시트 (20 페이지), 구성 (32 페이지)

페이지 인쇄

Connect the Cisco 800 Series Router to a PC

Follow these steps to connect the Cisco 800 series router to a PC:

Step 1

Connect the yellow Ethernet cable from the yellow Ethernet port (Cisco 801 and 802 routers) or from

the yellow Ethernet port with the number 0 (Cisco 803 and 804 routers) on the back panel of the router

to the Ethernet port on the NIC on the computer.

Figure 2

Verify that the HUB/NO HUB switch on the left side of the back panel has been set to the NO HUB

Step 2

position (out). If the button is in, press it to set it to the out position.

The HUB/NO HUB button corresponds to the Ethernet port on Cisco 801 and 802 routers and to

Note

Ethernet port 0 on Cisco 803 and 804 routers.

For Cisco 803 and 804 routers, connect additional computers to the Cisco 800 series router by

Step 3

connecting Ethernet cables from the Ethernet ports labeled with the numbers 1, 2, and 3 to the Ethernet

ports on the computers.

Caution

Always connect the yellow cable or Ethernet cable that you supply to the yellow ports on the router.

Do not connect the cable to an ISDN S/T or U port or to a Network Termination 1 (NT1) device.

Accidently connecting the cable to the wrong port can damage your router.

78-5374-03

Connecting a Cisco 800 Series Router to a PC

HU B

NO HU B

C is c o 8

ET HE RN

0 3

ET 10 BA

SE T

CO NS OL

IS DN S/

Cisco 803 router

PH ON E

Connect the Cisco 800 Series Router to a PC