Cisco 2800 Series 데이터시트 - 페이지 4

{카테고리_이름} Cisco 2800 Series에 대한 데이터시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 2800 Series 8 페이지. Cisco ios software configuration
Cisco 2800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 빠른 시작 매뉴얼 (47 페이지), 애플리케이션 노트 (41 페이지), 빠른 시작 매뉴얼 (45 페이지), 구성 (10 페이지), 개요 (27 페이지), 데이터시트 (5 페이지), 데이터시트 (20 페이지), 구성 (32 페이지)

페이지 인쇄
Cisco 2800 Series 데이터시트
Feature
Alarm Detection
Relevant Management Information
Base (MIB) Support
Remote Management
Signaling Debugging

HARDWARE SPECIFICATIONS

Table 4 shows the hardware specifications for the Cisco E1/T1 ISDN PRI Network Module.
Table 4.
Hardware Specifications for the Cisco E1/T1 ISDN PRI Network Module
Feature
Dimensions (H x W x D)
Operating Temperature
Nonoperating Temperature
Relative Humidity
LEDs
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Description
•
Controller local loopback
•
Controller remote loopback
CSU loopback modes for T1 CSU
•
Data terminal equipment (DTE) loopback
•
Network loopback
•
Payload loopback
•
V.54
•
Yellow Alarm—Receive/Send from/to network
•
Blue Alarm—Receive alarm indication signal (AIS) from network
•
Red Alarm—Loss of network signal
•
RFC1406-MIB
•
CISCO-ICSUDSU-MIB
•
Supported by Cisco WAN Access Performance Management System (WAPMS)
•
Cisco Intelligence Engine (IE2100)
•
CiscoWorks
•
CAS debugs
•
ISDN Q.921 and Q.931 decode
•
All other previously existing applicable Cisco IOS debugs
Description
•
1.55 x 7.10 x 7.2 inches
•
3.9 x 18.0 x 18.3 centimeters
32 to 104° F (0 to 40° C)
–40 to 185° F (–40 to 85° C)
5-95% non-condensing
LEDs per port
•
T1: T1 mode selected
•
E1-BAL: E1 balanced mode selected
•
E1-UNBAL: E1 unbalanced mode selected
•
CD: Carrier detect
•
LP: Loop condition present
•
RA: Remote alarm detected
•
LA: Local alarm detected
© 2005 Cisco Systems, Inc. All rights reserved.
Page 4 of 8