Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 10

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 37 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼
Before you run Express Setup, you must set up your switch module to communicate with a
Hyperterminal program.
The initial configuration assumes that the switch module was never configured, that it is in
Note
the same state as when it was received, and that it is not configured with a default username
and password.
To set up the switch module by using the command-line interface (CLI), see the switch module
Note
hardware installation guide on cisco.com.

Information You Need to Run Express Setup

You need this information about your switch module from your system administrator before you
complete the setup program:
• Fixed IP address
• Subnet mask (IP netmask)
• Default gateway IP address
You can also configure these optional parameters through the Express Setup program:
• Local access password
• Telnet access password
• Names of the SNMP read and write community strings if you are going to use a
network-management program like CiscoWorks.
• Host name, system contact, and system location
When you first set up the switch module, you can use Express Setup to enter the initial IP information.
Doing this enables the switch module to connect to local routers and the Internet. You can then access
the switch module through the IP address for further configuration.
10