Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 17

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 37 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄

Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼

The Express Setup page appears.

Go to "Completing the Express Setup Fields" section on page 17 to finish setting up the switch

Step 8

module using the Express Setup screen of the Device Manager.

Completing the Express Setup Fields

Follow these steps to finish setting up the switch module:

Enter this information in the Network Settings fields:

Step 1

In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if

–

you want to change the management interface through which you manage the switch module

and to which you assign IP information. The VLAN ID range is 1 to 1001.

In the IP Address field, enter the IP address of the switch module. In the IP Subnet Mask field,

–

click the drop-down arrow, and select an IP Subnet Mask.

In the Default Gateway field, enter the IP address for the default gateway (router).

–

Enter your password in the Switch Password field. The password can be from 1 to 25

–

alphanumeric characters, can start with a number, is case sensitive, allows embedded spaces,

but does not allow spaces at the beginning or end. In the Confirm Switch Password field, enter

your password again.