Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 21

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 37 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼
No parity
–
1 stop bit
–
No flow control
–
4. Use the CLI to enter commands to configure the switch module. See the software configuration
guide and the command reference for more information.

Other Management Options

You can use SNMP management applications such as CiscoWorks Small Network Management
Solution (SNMS) to configure and manage the switch module. You also can manage it from an
SNMP-compatible workstation that is running platforms such as HP OpenView or SunNet Manager.
The Cisco IE2100 Series Configuration Registrar is a network management device that works with
embedded Cisco Networking Services (CNS) agents in the switch module software. You can use
IE2100 to automate initial configurations and configuration updates on the switch module.
See the "Accessing Help Online" section on page 23 for a list of supporting documentation.
Onboard Administrator Command-Line Interface
See the HP BladeSystem enclosure setup and installation guide at
http://www.hp.com/go/bladesystem/documentation
Administration CLI.
7

In Case of Difficulty

If you experience difficulty, help is available in this section and also on Cisco.com. This section
includes Express Setup troubleshooting, how to reset the switch module, how to access online help,
and where to find more information.
for information on how to use the Onboard
21