Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼 - 페이지 25

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 31 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (37 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지), 설치 매뉴얼 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 시작하기 매뉴얼
Insert the cable into the StackWise Plus port on the front panel of the switch. Insert the other
Step 3
end of the cable into the connector of the other switch.
Always use a Cisco-approved StackWise Plus cable to connect the switches.
Figure 11
Inserting the StackWise Plus Cables
S Y S T
U ID
S -M O D E
S -M S TR
S -M M B R
M O D E
C O N S
O L E
S F P 1 9
-2 0
When you remove the StackWise Plus cables from the connectors, replace the dust covers to protect
them from dust.
Removing and installing the StackWise Plus cable can shorten its useful life. Do not
Caution
remove and insert the cable more often than is absolutely necessary.
8
Connecting to the Switch Module Ports
This section describes how to connect to the fixed switch module ports and to the 10-Gigabit Ethernet
module slots.
Connect to 10/100/1000 Ports
The 10/100/1000 Ethernet ports use standard RJ-45 connectors with Ethernet pinouts. The maximum
cable length is 328 feet (100 meters). The 100BASE-TX and 1000BASE-T traffic requires Category 5,
Category 5e, or Category 6 UTP cable. The 10BASE-T traffic can use Category 3 or Category 4 cable.
1 9 -2 0
2 3 x
2 1 -2 2
S F P 2
1 -2 2
2 4 x
S T K A
S T K B
2 6 x
W S -C B
S 3 1 2 0
G -S
25