Cisco 3020 - Cisco Catalyst Blade Switch 설치 매뉴얼 - 페이지 8

{카테고리_이름} Cisco 3020 - Cisco Catalyst Blade Switch에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3020 - Cisco Catalyst Blade Switch 21 페이지. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Cisco 3020 - Cisco Catalyst Blade Switch에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (37 페이지), 시작하기 매뉴얼 (31 페이지), 빠른 사양 (12 페이지), 릴리스 노트 (41 페이지), 릴리스 노트 (27 페이지), 릴리스 노트 (23 페이지), 릴리스 노트 (21 페이지)

페이지 인쇄
Cisco 3020 - Cisco Catalyst Blade Switch 설치 매뉴얼
Installing the Switch Module in the Blade Server
Figure 2-4
1
Push the release latch on the front of the switch module to the closed position.
Step 6

Switch Module IP Addresses

IP addresses can be assigned to two of the switch module interfaces:
•
•
If you want to assign the VLAN 1 IP address through Express Setup, you must start that process
immediately after installing the switch module in the blade server. If you miss the opportunity to have
the IP address assigned in this way, you can remove and then re-install the switch module. See the
"Running Express Setup" section on page 2-9
When you install the switch module, you need to determine whether the Onboard Administrator is
connected to a network in which a DHCP server is also connected or if the Onboard Administrator has
been configured as a DHCP server. If either of these conditions is true, the switch module automatically
Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide
2-8
Installing the Switch Module into the Blade Server Interconnect Module Bay
1
SYS T
STA T
DLX
17
UID
SPD
17x
MO DE
CO NSO
17x
WS -CB
21x
S-3 020
LE
20
-HP Q
17
18
19
20x
23x
20
24x
18x
24x
Switch module release latch
The fa0 Ethernet interface. This Layer 3 Ethernet interface is connected to the Onboard
Administrator through which you can manage the switch module. It is used only for switch module
management traffic, not for data traffic.
The VLAN 1 interface. You can manage the switch module from any of its external ports through
VLAN 1.
for instructions.
Chapter 2
Switch Installation
OL-8914-02