Cisco 3110 시작하기 - 페이지 35

{카테고리_이름} Cisco 3110에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3110 42 페이지.
Cisco 3110에 대해서도 마찬가지입니다: 매뉴얼 (42 페이지)

Getting Started

Step 3

Click the Deploy button in the menu to deploy your changes.

Changes are not active on the device until you deploy them. See

Searching for Rules or Objects

You can use full-text search on lists of policy rules or objects to help you find the item you want to edit. This

is especially helpful when dealing with policies that have hundreds of rules, or long object lists.

The method for using search on rules and objects is the same for any type of policy (except the intrusion

policy) or object: in the Search field, enter a string to find, and press Enter.

This string can exist in any part of the rule or object, and it can be a partial string. You can use the asterisk *

as a wildcard that matches zero or more characters. Do not include the following characters, they are not

supported as part of the search string: ?~!{}<>:%. The following characters are ignored: ;#&.

The string can appear within an object in the group. For example, you can enter an IP address and find the

network objects or groups that specify that address.

When done, click the x on the right side of the search box to clear the filter.

Deploying Your Changes

When you update a policy or setting, the change is not immediately applied to the device. There is a two step

process for making configuration changes:

1. Make your changes.

2. Deploy your changes.

This process gives you the opportunity to make a group of related changes without forcing you to run a device

in a "partially configured" manner. In most cases, the deployment includes just your changes. However, if

necessary, the system will reapply the entire configuration, which might be disruptive to your network. In

addition, some changes require inspection engines to restart, with traffic dropping during the restart. Thus,

consider deploying changes when potential disruptions will have the least impact.

Note

After you complete the changes you want to make, use the following procedure to deploy them to the device.

If the deployment job fails, the system must roll back any partial changes to the previous configuration.

Rollback includes clearing the data plane configuration and redeploying the previous version. This will disrupt

traffic until the rollback completes.

Searching for Rules or Objects

Deploying Your Changes, on page

Getting Started

35.