Sony XDCAM EX PMW-EX30 빠른 시작 매뉴얼
{카테고리_이름} Sony XDCAM EX PMW-EX30에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony XDCAM EX PMW-EX30 8 페이지. Xdcam ex family
Sony XDCAM EX PMW-EX30에 대해서도 마찬가지입니다: 브로셔 및 사양 (18 페이지), 브로셔 및 사양 (35 페이지), 제한 보증 (7 페이지), 매뉴얼 (3 페이지), 브로셔 (24 페이지), 브로셔 및 사양 (35 페이지)
페이지 인쇄
Getting Started
Overview
This document describes how to use the XDCAM EX
Version Up Tool (hereafter "Version Up Tool") to
upgrade the PMW-EX30. Use a USB cable to connect the
PMW-EX30 to a computer with the XDCAM EX Version
Up Tool installed, and perform the upgrade from the
computer.
Note
The USB connector to be used for the upgrade is a
dedicated connector for upgrade located under the upper
panel of the PMW-EX30.
See "Connecting the Computer and PMW-EX30"
(page 1) for details.
Refer to the PMW-EX30 Operating Instructions for
details on using the PMW-EX30.
To check the current version
To display the version, select "Version" from the
OTHERS menu.
Version Up Tool system requirements
Hard Disk Space
Approx. 50 MB
OS/CPU
Windows
OS
The 32 bit and 64 bit
versions of the following
OS
• Microsoft Windows
XP (Service Pack3 or
a)
later)
• Microsoft Windows
Vista (Service Pack2
or later)
• Microsoft Windows 7
CPU Intel x86 architecture
CPU
(Excluding Itanium
CPUs)
a) Microsoft .NET Framework 3.5 or higher must be installed.
* Microsoft, Windows, Windows Vista, and Windows 7 are registered
trademarks of Microsoft Corporation in the United States and other
countries.
©2012 Sony Corporation
Mac
The 32 bit version of the
following OS
• Mac OS X v10.4 (Tiger)
• Mac OS X v10.5
(Leopard)
• Mac OS X v10.6 (Snow
Leopard)
Intel x86 architecture CPU
(Excluding PowerPC
CPUs)
Notes on performing upgrade
• If you are using a Windows computer, you must have
the standard device driver supplied with Windows.
• If the computer's OS is Windows Vista or Windows 7,
then you must have administrator privileges.
• If the computer's OS is Windows XP, then the
Microsoft .NET Framework runtime is required.
• Only connect one PMW-EX30 camcorder to the
computer for upgrade.
• Supply AC power to the PMW-EX30 through the AC
adaptor supplied with the PMW-EX30.
• If you interrupt the upgrade process, you must start over
from the beginning. You cannot interrupt the process
after installing some of the modules, and then resume
the process where you left off.
Connecting the Computer and
PMW-EX30
To connect a PMW-EX30
1
Remove the connector cover in the top right corner of
the upper panel of the PMW-EX30 to reveal the
dedicated USB connector for upgrade.
PMW-EX30
4-432-490-11 (1)