ACU-RITE 00276TX 사용 설명서 - 페이지 5
{카테고리_이름} ACU-RITE 00276TX에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ACU-RITE 00276TX 7 페이지. Room monitor
페이지 인쇄Troubleshooting
Problem
•
O^kb_r ma^ Fhgbmhk bl ieZ\^] ZpZr _khf Zgr a^Zm
Inaccurate
sources or vents (see page 5).
temperature or
•
O^kb_r ma^ Fhgbmhk bl ihlbmbhg^] ZpZr _khf fhblmnk^
humidity
sources (see page 5).
•
Check that the batteries are installed correctly.
Batteries may need to be replaced.
Display screen
not working
•
K^l^m ]blieZr [r ik^llbg` ma^ K>L>M [nmmhg% eh\Zm^]
on the back of the Monitor.
•
Check the cord on the wired sensor (sold
Display screen shows
separately) and the connection tip for excessive
ERROR 1
heat, excessive cold or damage. Wired sensor may
need to be replaced.
•
=ZmZ k^Z]bg`l _hk ma^ pbk^] l^glhk !lhe] l^iZkZm^er"
may be out of range. Check the location of the
Display screen shows
Fhgbmhk Zg] pbk^] l^glhk' O^kb_r maZm ma^ \hg]bmbhgl
ERROR 2
being monitored are within the measurement range
for the wired sensor.
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.
Care & Maintenance
<e^Zg pbma Z lh_m% ]Zfi \ehma' =h ghm nl^ \Znlmb\ \e^Zg^kl hk Z[kZlbo^l'
Kh][aÚ[Ylagfk
-4ºF to 158ºF; -20ºC to 70ºC
TEMPERATURE RANGE
HUMIDITY RANGE
1% to 99% RH
330ft / 100m
WIRELESS RANGE
OPERATING FREQUENCY
433.92MHz
POWER
2 x AA alkaline batteries
Possible Solution
depending on home construction materials
8
FCC Information
Mabl ]^ob\^ \hfieb^l pbma iZkm *. h_ ?<< kne^l' Hi^kZmbhg bl ln[c^\m mh ma^ _heehpbg` mph \hg]bmbhgl3
*& Mabl ]^ob\^ fZr GHM \Znl^ aZkf_ne bgm^k_^k^g\^% Zg]
2- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
ma^ ^jnbif^gm h__ Zg] hg% ma^ nl^k bl ^g\hnkZ`^] mh mkr mh \hkk^\m ma^ bgm^k_^k^g\^ [r hg^ hk fhk^ h_ ma^ _heehpbg` f^Zlnk^l3
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
<hglnem ma^ ]^Ze^k hk Zg ^qi^kb^g\^] kZ]bh(MO m^\agb\bZg _hk a^ei'
GHM>3 Ma^ fZgn_Z\mnk^k bl ghm k^lihglb[e^ _hk Zgr kZ]bh hk MO bgm^k_^k^g\^ \Znl^] [r ngZnmahkbs^] fh]bÛ\Zmbhgl mh mabl ^jnbif^gm'
Ln\a fh]bÛ\Zmbhgl \hne] ohb] ma^ nl^k Znmahkbmr mh hi^kZm^ ma^ ^jnbif^gm'
This device complies with Industry Canada's licence-exempt RSSs.
Hi^kZmbhg bl ln[c^\m mh ma^ _heehpbg` mph \hg]bmbhgl3
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.
Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada .
Son fonctionnement est soumis aux deux conditions suivantes :
( 1 ) Ce dispositif ne peut causer d'interférences ; et
( 2 ) Ce dispositif doit accepter toute interférence , y compris les interférences
qui peuvent causer un mauvais fonctionnement de l'appareil.
9