Cisco 3750G - Catalyst Integrated Wireless LAN Controller 시작하기 매뉴얼 - 페이지 5
{카테고리_이름} Cisco 3750G - Catalyst Integrated Wireless LAN Controller에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3750G - Catalyst Integrated Wireless LAN Controller 49 페이지. Integrated wireless lan controller switch
Cisco 3750G - Catalyst Integrated Wireless LAN Controller에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지)
페이지 인쇄
Press and hold the Mode button for
Step 5
3 seconds. When all of the LEDs
above the Mode button turn green,
release the Mode button.
If the LEDs above the Mode button
begin to blink after you press the
button, release it. Blinking LEDs
mean that the switch has already
been configured and cannot go into
Express Setup mode. For more
information, see the "Resetting the
Switch" section on page 35.
Verify that the switch is in Express Setup mode by confirming that all LEDs above the
Step 6
Mode button are green. (On some switch models, the RPS LED remains off.)
Connect a straight-through
Step 7
Category 5 Ethernet cable (not
provided) to any 10/100/1000
Ethernet port on the switch front
panel and to the Ethernet port on the
PC.
Step 8
Verify that the LEDs on both Ethernet ports are green.
Wait 30 seconds.
Step 9
Step 10
Launch a web browser on your PC.
Enter the IP address 10.0.0.1 in the
web browser, and press Enter.
Mode button
SYST
RPS
MASTR
ST A T
DUPLX
SPEED
ST ACK
1
2
PoE
3
4
1X
5
6
7
8
9
10
11
12
11X
13
14
15
16
13X
17
18
19
20
2X
21
12X
14X
SY ST
RP S
MA ST R
ST A T
DU PL X
SP EE D
ST AC K
Po E
Cata lyst
3750 G
Wire less
SERIES
PoE- 24
LAN Cont
rolle r
22
23
24
23X
24X
25
26
DHCP-enabled PC
5