Argo XFETTO DCI HPL 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Argo XFETTO DCI HPL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo XFETTO DCI HPL 17 페이지. Installation instructions for air conditioner

WARNING! The supplied plastic conduits can be used for

wall thickness up to 50 cm; in special cases (i.e. installations

in a garret) it can be necessary to utilise longer tubes. The

maximum allowable length is 2 m. You can go to any building

material retailer, buy the plastic tube of the same diameter

(ø160 mm), of the proper length and cover it outside with

insulating material (thickness: about 3-4 cm).

- Fix the suspension panel to the wall in the position indicated

on the full scale diagram.

The quantity and the type of rawl plugs (not supplied)

depends on the consistence of the wall; do not let any

space between the panel and the wall.

- Hang up the unit at the panel inserting the back fan outlet

in the grille.

- Predispose a condensate drainage toward the outside

(a) making a hole Ø 35 mm as indicated on the full scale

diagram; if it is not possible, maintain the condensate

tube inside (b) and make a proper drainage. Assure always

a positive slope of at least 1cm/m.

- Connect the unit inserting the plug in the power socket.

- Verify the correct operation.

(b)

Plastic tubes ø 160mm

Insulation

(a)

(b)