Cisco 5500 Series 매뉴얼 - 페이지 4
{카테고리_이름} Cisco 5500 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5500 Series 19 페이지. Cisco 8500 series
wireless lan controller
Cisco 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 설치 매뉴얼 (34 페이지), 구성 매뉴얼 (50 페이지)
페이지 인쇄
Checking Equipment Status
10/100 Mbps Fast Ethernet Switching Module (10/100BaseTX 12 Port) LEDs
The faceplate of each 10/100 Mbps Fast Ethernet Switching Module (Prod # WS-X5203) contains a
module STATUS LED, and two LEDs for each switching port. The LEDs provide status information for
the module and individual Fast Ethernet interface connections. The LEDs are described in
are shown in
Table 7-3
LED
STATUS
100 Mbps
LINK (bottom
LED)
Figure 7-3
10/100 Mbps FAST ETHERNET SWITCHING MODULE
Route Switch Module LEDs
The RSM (product number WS-X5302) LEDs, shown in
Figure 7-4
ROUTE SWITCH MODULE
Cisco MGC Software Release 7 Operations, Maintenance, and Troubleshooting Guide
7-4
Figure
7-3.
10/100 Mbps Fast Ethernet Switching Module (10/100BaseTX 12 Port) LEDs
Description
The switch performs a series of self-tests and diagnostic tests.
If it passes all the tests, the LED is green.
If it fails a test other than an individual port test fails, the LED is red.
During system boot or if the module is disabled, the LED is orange.
During self-test diagnostics, the LED is orange.
If the module is disabled, the LED is orange.
If the port is operating at 100 Mbps, the LED is green.
If the port is operating at 10 Mbps, the LED is off.
If the port is operational (a signal is detected), the LED is green.
If the link has been disabled by software, the LED is orange.
If the link is bad and has been disabled due to a hardware failure, the LED flashes
orange.
If no signal is detected, the LED is off.
10/100 Mbps Fast Ethernet Switching Module (10/100BaseTX 12 Port) LEDs
RSM (WS-X5302) LEDs
Chapter 7
Maintaining the Cisco Catalyst 5500 Multiswitch Router
Figure
7-4, are described in
Table 7-3
and
Table
7-3.
OL-0542-06