Cisco 5505 - ASA Firewall Edition Bundle 설치 매뉴얼 - 페이지 6
{카테고리_이름} Cisco 5505 - ASA Firewall Edition Bundle에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5505 - ASA Firewall Edition Bundle 14 페이지. Asa with firepower services
Cisco 5505 - ASA Firewall Edition Bundle에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 간편한 설정 매뉴얼 (11 페이지)
페이지 인쇄
Powering on the Cisco ASA 5505
Powering on the Cisco ASA 5505
Step 1
Step 2
Step 3
Step 4
Setting Up a PC for System Administration
Step 1
ASA 5505 Getting Started Guide
4-6
To power on the Cisco ASA 5505, perform the following steps:
Connect the power supply with the power cable.
Connect the small, rectangular connector of the power supply cable to the power
connector on the rear panel.
Connect the AC power connector of the power supply input cable to an electrical
outlet.
The Cisco ASA 5505 does not have a power switch. Completing Step
Note
powers on the device.
Check the power LED; if it is solid green, then the device is powered on.
For more information, see the
You can perform setup, configuration and management tasks from a PC using the
command-line interface or with the Adaptive Security Device Manager (ASDM)
application, which provides an intuitive graphical user interface (GUI).
In addition to configuration and management capability, ASDM also provides
configuration wizards for initial configuration, VPN configuration, and
high-availability configuration.
For more information about using ASDM for setup and configuration, see
Chapter 1, "Configuring the Adaptive Security Appliance."
To set up a PC from which you can configure and manage the Cisco ASA 5505,
perform the following steps:
Make sure that the speed of the PC interface to be connected to one of the Cisco
ASA 5505 inside ports is set to autonegotiate. This setting provides the best
performance.
Chapter 4
"Front Panel Components" section on page
Installing the ASA 5505
3
4-10.
78-18003-02