Argo DAKOTA 사용 설명서 - 페이지 7
{카테고리_이름} Argo DAKOTA에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo DAKOTA 10 페이지. Electric convector heater
페이지 인쇄
Connect the power cord to an appropriate power outlet (220-240V ~ 50-60Hz).
Press the power button located on the side of the convector, a beep will sound.
The button
will light up on the control panel. Then press the Standby button
on the convector. Press the same button to switch off the convector.
It is advisable to unplug the power cord if the product is not in use.
Heating mode selection button
Press this button to select the heating mode between high and low. According to the selection made on the
display, the corresponding LEDs will light up:
Icon on display
Heating power
V 05/21
CONTROL PANEL AND FUNCTIONS
TOUCH CONTROL PANEL ON THE APPLIANCE
4
1
5
1
Low power heating LED
2
High power heating LED
3
Display Temperature/Timer
4
Standby button
5
6
Heating setting button
7
8
Brightness/Timer button
Low 1250W
6
Button -
Button +
High
2000W
8
3
2
7
LED on display
Operation buttons
on the panel to switch
17