Argo HIFAN digit plus 사용자 설명서 - 페이지 2

{카테고리_이름} Argo HIFAN digit plus에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo HIFAN digit plus 4 페이지.

read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information.
Failure to comply with instructions could result in personal injury and/or property damage. retain these instructions for
future reference.
FAN
LOW
HIGH
AUTO

°C

:
°C
FAN

°C
1. Use this heater only as described in this manual. any other use not recommended by the manufacturer may cause fire, electrical shock, or
injury to people.
2. make certain that the power source conforms to the electrical requirements of heater. (aC220-240V/50hz)
3. extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating unattended.
4. to reduce the risk of electric shock, this plug is intended to fit in a correct outlet. if the plug of heater does not fit fully in the outlet, contact a
qualified electrician. Do not attempt to defeat this safety feature.
5. Where possible, avoid to use of extension cords because the extension cord may overheat and cause a risk of fire. Never use a single exten-
sion cord to operate more than one heater.
6. Do not operate heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. return
heater to an authorized service facility for examination, electrical or mechanical adjustment or repair.
7. if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a
hazard.
8. turn off the power switch and unplug power cord before servicing or moving the heater. always unplug heater when not in use..
WARNING: DO NOT DEPEND ON THE ON/OFF BUTTON SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN
SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE POWER CORD.
9. to disconnect heater, turn switch to off position, then remove plug from outlet. Pull only by the plug. Do not pull on the cord when discon-
nect heater.
10. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire or da-
mage the heater. Do not block or tamper with the heater in any manner while it is in operation.
11. to prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place heater on soft surfaces, like a bed, where ope-
nings may become blocked.
12. always place the heater on a stable, flat, level surface when operating, to avoid the chance of the heater overturning. Locate the power
cord so the heater or other objects are not resting on it. Do not run power cord under carpeting. Do not cover power cord with throw rugs,
runners, or the like. arrange power cord away from room traffic and where it will not be tripped over.
13. this heater is hot when in use. to avoid burns, do not let bare skin touch hot surfaces. always use handle when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 0.9m from the front of the heater and keep
them at least 0.3m from the sides and rear.
14. a heater has hot and arcing or sparking parts inside. it must not be used in potentially dangerous locations such as flammable, explosive,
chemical-laden or wet atmosphere.
15. this heater is not intended for use in wet or damp locations. Never locate a heater where it may fall into a bathtub or other water container.
16. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
17. Do not use heater outdoors.
18. in order to avoid overheating, do not cover the heater.
19. the heater must not be located immediately below a socket- outlet.
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
DO NOT USE THIS HEATER WITH ANY SPEED CONTROL DEVICES.
HiFan Digit_EG_2009_v2.indd 2
reaD aND SaVe theSe iNStrUCtiONS
GeNeraL SaFetY iNFOrmatiON
LOW
HIGH


°C
°C
AUTO

°C

°C
V 02/09
1. ON/OFF/mODe switch
2. timer knob
3. indicator
4. Front netting
5. Base
6. LCD
7. - knob
8. Swing knob
9. + knob
10. Power switch
11. Front enclosure
12. rear enclosure
13. Power cord
29/06/2009 15.25.30