Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 매뉴얼 - 페이지 3

{카테고리_이름} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 페이지. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion에 대해서도 마찬가지입니다: 설치 참고 사항 (14 페이지), 솔루션 매뉴얼 (17 페이지), 설치 참고 사항 (46 페이지), 백서 (19 페이지), 설명 (1 페이지), 제품 게시판 (6 페이지), 공지 사항 (4 페이지), 데이터시트 (9 페이지), 데이터시트 (18 페이지), 백서 (18 페이지), 구성 매뉴얼 (8 페이지), 설치 참고 사항 (28 페이지), 문제 해결 매뉴얼 (11 페이지), 설치 참고 사항 (18 페이지), 사용자 설명서 (17 페이지), 설치 참고 사항 (24 페이지), 설치 참고 사항 (36 페이지)

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 매뉴얼
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
need to provide an RJ-45-to-DB-25 female data terminal equipment (DTE) adapter if you want to
connect the switch console port to a terminal. You may order a kit (part number ACS-DSBUASYN=)
containing the adapter from Cisco. The PC or terminal must support VT100 terminal emulation. The
terminal emulation softwarefrequently a PC application such as Hyperterminal or Procomm Plusmakes
communication between the switch and your PC or terminal possible during the setup program.
Follow these steps to connect the PC or terminal to the switch:
1.
Be sure that your PC or terminal emulation software is configured to communicate with the switch
via hardware flow control.
2.
Configure the baud rate and character format of the PC or terminal to match these console port
default characteristics:
9600 baud
8 data bits
1 stop bit
No parity
3.
Using the supplied rollover cable, insert the RJ-45 connector into the console port.
4.
Attach the supplied RJ-45-to-DB-9 female DTE adapter to a PC, or attach an appropriate adapter
to the terminal.
5.
Insert the other end of the supplied rollover cable in the attached adapter.
6.
Run the terminal emulation program if you are using a PC or a terminal.
Table A-1: Console Port Signaling and Cabling Using a DB-9 Adapter
Console
RJ-45-to-RJ-45
Port
Rollover Cable
(DTE)
RJ-45
Signal
Pin
RTS
1
http://www.cisco.com/warp/public/473/9.html (3 of 19) [9/4/2003 12:36:02 PM]
RJ-45-to-DB-9
Terminal
Adapter
RJ-45
DB-9 Pin
Pin
8
8
Console
Device
Signal
CTS