Cisco 7200-I/O-2FE/E 사용자 설명서 - 페이지 3

{카테고리_이름} Cisco 7200-I/O-2FE/E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7200-I/O-2FE/E 16 페이지. Input/output controllers

Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers

Supported Standards, MIBs, and RFCs

Standards

No new or modified standards are supported by this feature.

MIBs

No new or modified MIBs are supported by this feature.

For descriptions of supported MIBs and how to use MIBs, see the Cisco MIB web site on CCO at

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.

RFCs

No new or modified RFCs are supported by this feature.

See the following sections for configuration tasks for the Cisco 7200-I/O-GE+E and the

Cisco 7200-I/O-2FE/E feature. Each task in the list indicates if the task is optional or required.

•

For Cisco 7200 VXR routers used as router shelves in AS5800 Universal Access Servers,

Note

use the router-shelf/slot/port command format for all interface commands.

Configuring the Interface Transmission Mode

This section describes the procedure for configuring the interface transmission mode. The Fast Ethernet

and Ethernet interfaces on the Cisco 7200-I/O-2FE/E are duplex auto by default.

Command

Step 1

Router(config)# configure terminal

Step 2

Router(config-if)# interface fastethernet 0/0

Step 3

Router(config-if)# duplex full

Use the interface fastethernet router-shelf/slot/port command for a Cisco 7200 VXR used as a router shelf in an AS5800 Universal Access

Server.

Configuring the Interface Transmission Mode (Optional)

Configuring Interface Speed (Optional)

Configuring the Ethernet, Fast Ethernet, and Gigabit Ethernet Interfaces (Required)

Verifying the Configuration (Optional)

Purpose

Enters configuration mode and specifies that the

console terminal is the source of the configuration

subcommands.

Selects the Fast Ethernet interface to configure.

Changes the Fast Ethernet interface port

transmission mode to full duplex from

autonegotiation.

Supported Standards, MIBs, and RFCs

12.1(5)T and 12.2(14) S