Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 33

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Install Field Replaceable Units (FRUs)

Copy the Conﬁguration File for

an RSP

Refer to the appropriate Cisco IOS software

documentation for the conﬁguration options

available, and for speciﬁc conﬁguration instructions,

as needed.

Before you copy (save) the running conﬁguration to

a TFTP ﬁle server, ensure the following:

•

You have a connection to the router either with

a console terminal connected to the RSP console

port or remotely through a Telnet session.

•

The router is connected to a network supporting

a ﬁle server (remote host).

•

The remote host supports the TFTP application.

•

You have the interface processor address or

name of the remote host available.

Step 1

Enter the enable command at the EXEC

prompt (>), and then enter a

privileged-level password, as follows:

Router> enable

Password:

Router#

Step 2

Enter the ping command followed by the

name or IP address of the remote server,

and then press Return to check the

connection between the router and the

remote host.

Step 3

Enter the show running-conﬁg command

to display the currently running

conﬁguration on the terminal and ensure

that the conﬁguration information is

complete and correct. If it is not, use the

conﬁgure command to add or modify the

existing conﬁguration.

Step 4

Create a ﬁle on the TFTP server.

Note

Before you can save a ﬁle to a TFTP server, a

ﬁle must ﬁrst exist on the TFTP server. Create this

ﬁle. Ensure that the ﬁlename matches the ﬁlename

you will copy from the router. Also, ensure that the

server permissions are set so the router can copy to

this ﬁle.

Step 5

Enter the copy startup-conﬁg tftp

command. The EXEC command

interpreter prompts you for the name or

interface processor address of the remote

host that is to receive the conﬁguration

ﬁle. (The prompt might include the name

or address of a default ﬁle server.)

Router# copy startup-config tftp

Remote host []?

Step 6

Enter the name or IP address of the remote

host. In the following example, the name

of the remote server is servername:

Router# copy startup-config tftp

Remote host []? servername

Translating "servername"...domain server

(1.1.1.1) [OK]