Sony 6116.12 RX100 III 사용 설명서 - 페이지 14

{카테고리_이름} Sony 6116.12 RX100 III에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony 6116.12 RX100 III 32 페이지. Digital housing (dsc-rx100m3/b)

Using the Camera's Built-in Flash

If you are shooting with the camera's built-in flash and the camera lens

is set to the widest angle setting, you may need to zoom the lens slightly

or a dark area may appear in a lower corner of close-up photographs.

The lens port may block some of the light. Install the Diffuser, page 15,

and zoom in to eliminate any dark areas noted in your photographs (You

can test this above water).

For the best results, we recommend using external Strobes.

The camera's built-in flash CANNOT be used with optional Wide Angle or

Accessory lenses.

The factory installed flash Deflector should be removed and replaced by

the Diffuser, page 15, when using ONLY the built-in camera flash and no

external strobes. To remove, lift the bottom of the Deflector with your

thumb, or a Pen or Pencil tip to loosen and pull the Deflector away from

the inside front of the housing. To install, line up the corresponding

Velcro dots on the housing front with the Deflector Back and press the

Deflector into its factory installed position next to the lens port. If

positioned properly, the small deflector holes will line up with the Fiber

Optic Port holes.

Deflector Back

(view from inside housing)

Deflector Holes

Bottom of Deflector

Deflector Back

(view from outside housing)

Velcro