Sony 838 MHz to 862 MHz 브로셔 - 페이지 46

{카테고리_이름} Sony 838 MHz to 862 MHz에 대한 브로셔을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony 838 MHz to 862 MHz 48 페이지. Sony digital camera brochure

페이지 인쇄
Sony 838 MHz to 862 MHz 브로셔
Specifications
HARD DISK RECORDERS / FLEXICART
DSR-DR1000P
General
Power requirements
AC 100 V to 240 V, 50/60 Hz
Power consumption
60 W
Operating temperature
5 °C to 40 °C (41 °F to 104 °F)
Storage temperature
-20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity
Less than 80%
Storage humidity
Less than 90%
Mass
7.5 kg (16 lb 10 oz)
Dimensions (W x H x D)
210 x 130 x 422 mm (8 3/8 x 5 1/8 x 16 5/8 inches, without projection)
Video Performance
Bandwidth
Luminance: 25 Hz to 5.0 MHz +1.0
(via analogue component I/O)
Chrominance: 25 Hz to 2.0 MHz +1.0/-2.0 dB
S/N ratio
More than 54 dB
(via analogue component I/O)
K-factor (K2T, KPB)
Less than 2%
Y/C delay
Less than 30 ns
Audio Performance
Frequency response
2CH mode (48 kHz/16-bit): 20 Hz to 20 kHz ±1.0 dB
4CH mode (32 kHz/12-bit): 20 Hz to 14.5 kHz ±1.0 dB
Dynamic range
More than 87 dB
Distortion (THD + N)
Less than 0.07% (48 kHz)
Input Signals
VIDEO (ANALOGUE)
REF. Video: BNC (2)
0.3 Vp-p, 75 Ω sync negative
Composite Video: BNC (2), loop-through connection (*
1.0 Vp-p, 75 Ω, sync negative
Component: BNC (3) (*
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y, B-Y: 0.7 Vp-p, 75 Ω (100% colour bar)
S-Video: BNC (2) (*
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
DSR-DU1
Hard Disk Recorder
General
Power requirements
DC 7.2 V (battery), DC 8.4 V (AC adaptor)
Power consumption
5.6 W
Mass
500 g (1 lb 1 oz)
Dimensions
(W x H x D) 44 x 101 x 142 mm
Operating temperature
0 °C to 40 °C
Storage temperature
-20 °C to 60 °C
Operating Humidity
Less than 85 % (without dew condensation)
Input/Output Terminals
DV IN/OUT
i.LINK x1 (IEEE1394 4-pin)
Remote
4-pin Stereo mini Jack x1
DC IN
x1
Supplied Accessories
Warranty card
Operation manual
i.LINK cable (4-pin to 4-pin)
Remote controller (RM-LG2)
Battery (CR2032)
Case
46
Hard Disk Recorder
1
)
1
)
1
)
VIDEO (DIGITAL)
SDI: BNC (1)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE)
Audio: XLR 3-pin female (2)
-6/-3/0/+4 dBu (selectable by menu), high impedance
AUDIO (DIGITAL)
AES/EBU: BNC (2)
75 Ω, unbalanced
Time Code
BNC (1), 0.5 Vp-p to 18.0 Vp-p, 3 kΩ unbalanced
Output Signals
VIDEO (ANALOGUE)
Video 1/2 (SUPER): BNC (2) (*
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component: BNC (3) (*
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y, B-Y: 0.7 Vp-p, 75 Ω (100% colour bar)
S-Video: BNC (2) (*
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω (at burst level)
VIDEO (DIGITAL)
SDI: BNC (2)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE)
Audio: XLR 3-pin male (2)
-6/-3//0/+4 dBu (selectable by menu)
Monitor: RCA (1)
-9 dBu, 47 kΩ, unbalanced (-18 dBFS), volume center
Headphone: JM-60 headphone jack (1)
- ∞to -11 dBu, 8 Ω, unbalanced (-18 dBFS)
AUDIO (DIGITAL)
AES/EBU: BNC (2), 75 Ω, unbalanced
TIME CODE
BNC (1), 2.2 Vp-p, 600 Ω, unbalanced
REMOTE
RS-422A: D-sub 9-pin, female (2)
Control: Mini jack (1)
Network
Ethernet (1): 10Base-T/100Base-TX Ethernet, RJ-45 modular jack
2
)
2
)
2
)