Sony A 7 R IV 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Sony A 7 R IV에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony A 7 R IV 6 페이지.
페이지 인쇄recording information display with the memorized white balance retained.
The custom white balance setting registered in this operation is effective until
a new setting is registered.
8. If you get the message "Custom WB error" this indicates that you need to
adjust your exposure and reattempt to set your white balance.
9. Remove the ExpoDisc, return the camera to auto focus if desired and start
shooting.
Sony A77
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the "P", "S" or "A"
modes or set the correct manual exposure in "M" mode.
3. Press the WB (White Balance) button > Select (
the Multi-Selector.
4. Aim the camera in the appropriate direction for the given lighting condition
and press the shutter release button. See the ExpoDisc Instruction Manual for
more information on where to aim the camera.
5. The shutter clicks and the calibrated values (ColorTemperature and Color
filter) are displayed.
6. Select a register using the multi-selector, then press the center of the multi-
selector. The A77 allows you to set and save 3 custom white balance
settings.
7. The monitor returns to the recording information display with the memorized
white balance setting retained. The custom white balance setting registered
in this operation is effective until a new setting is registered.
8. If you get the message "Custom WB error" this indicates that you need to
adjust your exposure and reattempt to set your white balance.
9. Remove the ExpoDisc, return the camera to auto focus if desired and start
shooting.
Sony A100
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the "P", "S" or "A"
modes or set the correct manual exposure in "M" mode.
3. Rotate the function dial on the top-left of the camera to the WB position.
4. Press the Fn button in the center of the function dial to display the White-
Balance mode screen.
5. Using the controller pad to the right of the screen, move up or down to select
the custom white balance icon (
6. Select
(set) by pressing
the controller. "Use spot metering area. Press shutter to calibrate." will
appear on the screen.
Copyright, 2020 ExpoImaging, Inc.
"Sony" and the Sony camera models listed are trademarks of Sony, Inc.
SET) > Press the center of
) and press
on the controller pad.
on the controller. Press the center button on