Sony Alpha SLT-A65 서비스 매뉴얼 - 페이지 8
{카테고리_이름} Sony Alpha SLT-A65에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony Alpha SLT-A65 36 페이지. Correction and notes on shooting with the viewfinder
Sony Alpha SLT-A65에 대해서도 마찬가지입니다: 수정 (2 페이지), 기능 설명서 (3 페이지)
페이지 인쇄
Ver. 1.2 2012.04
The changed portions from
Ver. 1.1 are shown in blue.
1-6. METHOD FOR REPLACING THE AS SLIDER B ASSY
Removal Procedure
(1) Remove the spring.
Spring
(2) Remove the solder on the enamel wires at two places.
Solder
Solder
(3) Remove the flexible board from the AS Slider B Assy.
Flexible Board
(4) Remove the two screws.
(5) Remove the AS Unit Holder Ball.
AS Unit Holder Ball
(6) Remove the two Ball Bearings.
Ball Bearing
Ball Bearing
SLT-A65/A65K/A65L/A65M/A65V/A65VK/A65VL/A65VM/A65VX/A65VY/A65X/A65Y_L2
(7) Remove the Cap SPs (for Pitch and Yaw).
Cap SP
(8) Remove the Caps (for Pitch and Yaw).
Cap
(9) Remove the AS Slider A Assy.
It can be done easily if A is removed beforehand.
A
AS Slider A Assy
(10) Remove the AS Slider B Assy.
It can be done easily if B is removed beforehand.
B
AS Slider B Assy
(11) Remove the three Ball Bearings.
Ball Bearing
Assembly Procedure
Note: Make sure to perform the assembly procedures after assembling the AS Holder Actuator Assy.
The assembly procedure is the reverse of the removal procedure.
Apply grease to the portions indicated below.
* After applying grease, attach the Ball Bearings.
Ball Bearing
G G-15
G G-15 and G G-116
AS Slider B Assy
* After applying grease, attach the Ball Bearings.
Ball Bearing
G G-15
Ball Bearing
G G-15
1-4
– ENGLISH –