Cisco ACC-7010CBLM= 설치 지침 매뉴얼 - 페이지 12

{카테고리_이름} Cisco ACC-7010CBLM=에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ACC-7010CBLM= 15 페이지. Rack-mount and cable management kits

Installing the Cable Management Brackets

The cable management brackets attach to the inner sides of the chassis at the interface processor end.

(See Figure 7.)

Note

Use the brackets to keep network interface cables untangled and orderly, provide strain relief, and

prevent cables from hindering access to interface processors in the lower interface processor slots.

Install the brackets before connecting network interface cables to the interface processor ports;

otherwise, you will probably need to disconnect the cables to install the screws that secure the

brackets. Route interface cables through the cable management brackets as you connect them to the

interface processor ports. If necessary, wrap cable ties through the holes provided to secure

small-gauge cables.

Figure 7

Follow these steps to install the two cable management brackets on the interface processor end of

the chassis:

Step 1

Step 2

Step 3

Step 4

Step 5

12 Cisco 7010 and Cisco 7505 Rack-Mount and Cable Management Kits Installation Instructions

For this procedure, the Cisco 7010 and Cisco 7505 chassis are functionally the same.

Cable Management Brackets—Cisco 7010 Chassis Shown

Verify that you have all the parts you will need: two cable management brackets and six

M3 x 8-mm, Phillips panhead screws.

At the interface processor end of the chassis, place a bracket on an inner side of the chassis

and align the three holes in the bracket with the holes in the chassis. (See Figure 7.)

Insert and ﬁnger-tighten three M3 Phillips screws from the inner side of the chassis,

through the bracket and into the chassis.

When all three screws are inserted, use the number 1 Phillips screwdriver to tighten the

screws.

Repeat Steps 2 through 4 for the second bracket.