Cisco Aironet 1000 Series 업그레이드 - 페이지 13

{카테고리_이름} Cisco Aironet 1000 Series에 대한 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1000 Series 28 페이지. Install and upgrade internal modules and field replaceable units
Cisco Aironet 1000 Series에 대해서도 마찬가지입니다: 배포 매뉴얼 (40 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

Install and Upgrade Internal Modules and Field Replaceable Units

Figure 7: Attaching the Antennas

Step 1

Use your thumb and index finger to insert and tighten antenna 1 and antenna 3 in the middle antenna attachment slots,

as indicated in the figure.

While installing the antennas, first install antenna 1 and antenna 3 (this instruction is for the two antenna

Note

attachments present in the middle) and secure it completely. If you install antenna 2 and antenna 0 first (this

refers to the first and the last antenna attachments), there will be less space to insert your thumb and index

finger and therefore, you may not be able to secure antenna 1 and 3.

Step 2

Insert antenna 2 and antenna 0 in the first and last antenna attachment slots.

Step 3

After installing the antennas, adjust the antenna orientation by spacing out each of them equally until they are spread out.

This is important because it helps in getting higher RF performance.

Install and Upgrade Internal Modules and Field Replaceable Units

Configuring a Pluggable Interface Module