Argo Wallner C860 사용 설명서 - 페이지 12

{카테고리_이름} Argo Wallner C860에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Wallner C860 14 페이지.

페이지 인쇄

PROBLEM SOLVING

problems

No operation

No operation after

long time operation

Stop at shredding

Excess squeaking

and rubbing noise

Paper jam

MALFUNTION / MAINTENANCE

If any faults should appear, please pass the machine along with the warranty card to the

seller or closest authorised dealer. The machine might be passed futher, thus the user sho-

uld maintain the original and complete packaging. In cases when the machine is passed for

repair in a not original or incomplete package, the risks of futher damages that might arise

in transportation are on the user's side. Thus, in such a case, it is in the user's best interest

to make the best possible replacement packaging.

checklists

Is the power plug properly

inserted to main power supply?

Is the switch set to

position?

Is the switch at „AUTO" position,

but power light is off?

Is the basket on the stand, but

power light is off?

No operation when you insert the

paper?

You checked the above, but no

operation and no power light?

Power lamp is on?

Machine is continuously

shredding for a long time?

Without oiling of the cutting

system periodically, squeaking

and rubbing noise will increase

while shredding.

- Did you exceed the shredding

capacity

- Is the paper fed squarely into

the feed opening.

solutions

Fully put the power plug to the

outlet.

„AUTO"

Set switch to „AUTO" position

for operation.

Check if basket is out of stand.

Put basket back on stand.

Basket should be put on the

stand to trigger the safety

interlock switch for operation.

Paper should be inserted to

trigger the sensor in the centre.

Send back to your local service

for repair.

Unplug the

main supply. Allow it to cool

down to

room temperature

and resume operation.

Unplug the

main supply. Allow it to cool

down to

room temperature

and resume operation.

Perform

the

instruction to lubricate the

cutting system.

Set switch to „REV" for reverse

running and free excess paper.

Then set to „AUTO" for cutting

the remaining paper in the

cutting system. If serious jam

occurred, send back to local

service for repair.

machine

from

machine

from

cutter

oiling