Cisco Aironet 1140 Series 시작하기 매뉴얼 - 페이지 14

{카테고리_이름} Cisco Aironet 1140 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1140 Series 35 페이지. Autonomous access point
Cisco Aironet 1140 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (37 페이지), 시작하기 매뉴얼 (31 페이지)

페이지 인쇄

Guidelines for Using Cisco Aironet Lightweight Access Points

Keep these guidelines in mind when you use an 1140 series lightweight access point:

• The access point can only communicate with Cisco controllers, such as the 2106 series wireless

LAN controllers or 4400 series controllers.

• The access point does not support Wireless Domain Services (WDS) and cannot communicate with

WDS devices. However, the controller provides functionality equivalent to WDS when the access

point joins to it.

• CAPWAP does not support Layer 2. The access point must get an IP address and discover the

controller using Layer 3, DHCP, DNS, or IP subnet broadcast.

• The access point console port is enabled for monitoring and debug purposes (all configuration

commands are disabled when the access point is connected to a controller).

Using DHCP Option 43

You can use DHCP Option 43 to provide a list of controller IP addresses to the access points, enabling

them to find and join a controller. For additional information, refer to the "Configuring DHCP Option

43 and DHCP Option 60" section on page 31.

Checking the Access Point LED

Figure 4 shows the location of the access point Status LED.

Figure 4

Access Point LED Location

Status LED