Argo Wallner MR 2814 C2 사용 설명서 - 페이지 12

{카테고리_이름} Argo Wallner MR 2814 C2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Wallner MR 2814 C2 16 페이지.

OPERATION

FEEDING THE PAPER/ CREDIT CARDS/ CDS

1. Please check the voltage of your shredders carefully before using and then plug in and

press the switch to „I"

2. Press the power button, the blue light lights up and the shredder is going to standby

mode.

3. Make sure not to place more sheets of paper then the maximum amount indicated

by the producer.

4. Place the paper into the proper entry, the machine will start automatically. When the

shredding will be completed the machine will stop automatically.

5. Place the CD/credit card into the proper entry, the machine will start automatically.

When the shredding will be completed the machine will stop automatically.

6. Press Power to finish operation.

7. When the work has been completed, turn the switch into the (O) position and unplug

the machine.

CAUTION:

It is forbidden to place more sheets of paper then the maximum amo-

unt indicated by the producer. If the machine will be overloaded, then please proceed ac-

cording to the information given in the "paper jam" section.

CAUTION:

Never attempt to shred more than one credit card/CD at a time or the

shredder will jam. Never attempt to shred both paper and credit cards/CDs at the same

time. Doing so will damage the shredder.

MOTOR PROTECTION

When the Overload diode (3) lights up unplug the machine from the main power source.

Allow the motor to cool down to room temperature before resuming operation.

After cooling down, the shredder is ready to re-start to work. It is crucial to avoid the

situation when the thermal fuse will work - this type of usage of the shredder is not proper

and implies machine's overwork.

CUTTER OILING INSTRUCTIONS

To ensure proper operation and function, periodic oiling of the cutting system is required.

Failure to oil your cutting system could result in reduced sheet capacity performance,

excess noise, paper jams and possibly machine failure. Oil your cutters every 5th or 6th

time you empty the basket, if excess squeaking and rubbing noise is coming from the

machine or if the shredders sheet capacity has diminished.

Squeeze the lubricant across the full width of the cutters. Insert paper into sensor

to activate the cutting system forward for 3 seconds. Then press „Rev" to make

shredder reverse for 3 seconds. Alternate between forward and reverse at least

three times or until all paper clears the cutters.