Sony PlayStation Portable 사용 설명서 - 페이지 13

{카테고리_이름} Sony PlayStation Portable에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony PlayStation Portable 16 페이지. Screen replacement guide
Sony PlayStation Portable에 대해서도 마찬가지입니다: 안전 및 지원 (28 페이지), 빠른 참조 (33 페이지), 사용 설명서 (24 페이지), 사용자 설명서 (24 페이지), 사용 설명서 (20 페이지), 사용 설명서 (24 페이지), 사용 설명서 (40 페이지), 사용 설명서 (21 페이지), 수리 및 부품 (3 페이지), 빠른 시작 매뉴얼 (15 페이지), 안전 매뉴얼 (12 페이지), 사용 설명서 (4 페이지), 빠른 참조 (34 페이지), 사용 설명서 (2 페이지), 사용 설명서 (2 페이지), 안전 매뉴얼 (25 페이지)

페이지 인쇄
Sony PlayStation Portable 사용 설명서
B Operation with the
Mouse
You can also operate SoundScope using the
Mouse (SCPH-1090 : sold separately). Refer
to A for the operation.
A6
A!¡
A!£
A9
A!£
A8
For the CD operation screen
• To move the mouse pointer(+): Move the
Mouse.
• To select the items: Press the left button.
C Additional operations
Changing the size of the picture
Press the directional buttons (up or down)
while holding down ✕ button.
Changing and Storing the settings
1
During playback, press R1 button
....
while holding down ✕ button.
A mark flashes on the lower right of
the screen.
2
Operate the controller.
....
While the mark is lit, any changes you
make to the SoundScope operation
with the controller are stored.
3
....
When you are finished, press R1
button while holding down ✕ button.
The mark disappears and the
procedure is completed.
Note
Do not unplug the controller during the procedures.
Switching to stored settings
1
... During playback, press L1 button
while holding down ✕ button.
A mark appears on the lower left of the
screen, and the SoundScope picture is
transformed by the stored operation.
2
... Press L1 button while holding down ✕
button.
The mark disappears and the
procedure is completed.
Tip
Your stored setting is lost when you turn off the
"PlayStation". If you want to keep the data, you can
save and load it by using the MEMORY CARD with
one memory block.
Saving the stored operation in the
MEMORY CARD
Press R2 button while holding down ✕
button.
A mark appears on the upper right of the
screen.
Note
You can store only one custom setting of SoundScope
operation. If the data already exists, it is erased.
Loading the data in the MEMORY CARD
Press L2 button while holding down ✕
button.
A mark appears on the upper left of the
screen. To use the loaded data, follow the
procedure above.
13