Sony SLT-A33 서비스 매뉴얼 - 페이지 30
{카테고리_이름} Sony SLT-A33에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony SLT-A33 30 페이지. Interchangeable lens digital camera/zoom lens kit
Sony SLT-A33에 대해서도 마찬가지입니다: 기능 설명서 (7 페이지), 사양 (2 페이지)
페이지 인쇄
3-2. CLEANING PROCEDURE OF OLPF
<Preparation for Remedy>
If you use the new Jig (J-6082-663-A) below, make sure to clean the CCD Cleaning Jig (Tip) below before using, please.
Note: Protection sheet is for preventing the scratch of a surface on the Jig (Tip).
The protection sheet may be come off the Jig when you take the Jig from a bag, but it is no problem.
CCD Cleaning Jig
<Cleaning Procedure for Tip of CCD Cleaning Jig>
1. Put the two cleaning cloths on a tray like below.
1 Souse the one cleaning cloth in ethyl alcohol.
2 Put the other cleaning cloth on a tray as it is dry.
2. Dab the tip of CCD cleaning jig at the cleaning cloth of 1 5 or 6 times.
* Do not slide the tip from right to left or up and down while dabbing.
3. Dab the tip of CCD cleaning jig at the cleaning cloth of 2 5 or 6 times.
* Do not slide from right to left or up and down while dabbing.
4. Wait until the tip will be dried completely.
SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2
Protection Sheet
CCD Cleaning Jig (Tip)
CCD Cleaning Jig (New)
(J-6082-663-A)
1 Souse the cleaning
cloth in ethyl alcohol.
2 The dry cleaning cloth.
<Cleaning Procedure for the OLPF>
1. Clean up the tip of CCD cleaning jig.
2. Press the Mirror Lock Lever to raise the P.O.I.
3. Dab the tip of CCD cleaning jig at the OLPF, and pull up straight.
* Do not slide from right to left or up and down while dabbing.
4. Repeat "3" several times to clean up.
5. According to service manual, check if there is dirt on the CCD.
<ATTENTION>
If you cannot remove dirt with remedy above, cleaning by the following jig are used.
Soak a small amount of EE3310 (Liquid cleaner) after wrapping the cleaning cloth (J-6082-636-A) around the cleaning jig (J-6082-635-A).
Cleaning Cloth
(J-6082-636-A)
3-5E
OLPF
Mirror Lock Lever
Cut
EE3310
Cleaning Jig
(J-6082-635-A)