Sony XCD-SX90CR 기술 매뉴얼 - 페이지 4

{카테고리_이름} Sony XCD-SX90CR에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony XCD-SX90CR 38 페이지. Digital camera module
Sony XCD-SX90CR에 대해서도 마찬가지입니다: 매뉴얼 (4 페이지), 기술 매뉴얼 (39 페이지), 서비스 매뉴얼 (30 페이지), 운영 지침 (2 페이지)

페이지 인쇄

System Components

The camera module imaging system comprises the following products.

Products 1 to 4 are used for the basic configuration, and 1 to 7 for the optional configuration. (All the products

except the camera module are available separately.)

1 Camera module

This is a small-size, high-resolution, camera

module using a CCD image sensor.

2 IEEE1394b camera cable (commercially

available)

Connect this cable to the IEEE1394b connector on

the rear panel of the camera module. The power and

image/control signals are transmitted through this

cable. To prevent a poor connection or damage to

the camera or cable, use the cable equipped with

fixing screws.

3 C-mount lens (commercially available)

Use an appropriate lens for the camera module and

usage.

4 Camera module interface board (commercially

available)

Install the board in a PCI bus slot of a host device

such as a PC.

Select an IEEE1394 interface board to match your

system.

Select an IEEE1394b interface board if you use the

transfer speed of 800 Mbps.

5 VCT-ST70I tripod adaptor (Sony)

Attach this adaptor to the bottom of the camera

module to fix the camera module to a tripod.

6 DC-700/700CE camera adaptor (Sony)

7 CCXC-12P02N (2 m, 6.6 ft)/05N (5 m, 16.4 ft)/

Connect this adaptor to the camera module to

enable power supply from an ordinary AC power

source.

10N (10 m, 32.8 ft)/25N (25 m, 82 ft) camera

cable (Sony)

Connect this cable to the 12-pin I/O connector on

the rear panel of the camera module. The cable is

used for power supply and exchange of trigger

signals.