Sony XCD-U100CR 기술 매뉴얼 - 페이지 6

{카테고리_이름} Sony XCD-U100CR에 대한 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony XCD-U100CR 38 페이지. Digital camera module
Sony XCD-U100CR에 대해서도 마찬가지입니다: 매뉴얼 (4 페이지), 기술 매뉴얼 (39 페이지), 서비스 매뉴얼 (30 페이지), 운영 지침 (2 페이지)

페이지 인쇄
Sony XCD-U100CR 기술 매뉴얼
Location and Function
of Parts and Operation

Front/Top/Bottom

1 Lens mount (C-mount)
Attach any C-mount lens or other optical
equipment.
Note
The lens must not project more than 10 mm (13/32 inch)
from the lens mount.
1 Lens mount face 210 mm (13/32 inch) or less
2 Auxiliary holes (top)
3 Reference holes (bottom)
These precision screw holes are for locking the
camera module. Locking the camera module into
these holes secures the optical axis alignment.
For details, see "Dimensions" on page 37.
Four screw reference holes 3 can be used as the
tripod adaptor screw holes, too. Screw the VCT-
ST70I tripod adaptor into the four screw holes
when you use a tripod.
6

Rear

4 IEEE1394b connectors
Connect an IEEE1394b camera cable (not
supplied) to this connector.
Pin No.
Signal
1
TPB–
2
TPB+
3
TPA–
4
TPA+
5
TPAG
5 12-pin I/O connector
When power from the IEEE1394b connector is
insufficient, power is supplied through this
connector.
Connect a camera cable such as the CCXC-12P05N
to this connector.
Pin No.
Signal
1
Power GND
2
Power IN
3
ISO GND
4
Strobe OUT
5
GPIO OUT 1–
6
GPIO OUT 1+
Pin No.
Signal
6
VG
7
NC
8
VP
9
TPBG
Pin No.
Signal
7
GPIO IN 2
8
GPIO OUT 2–
9
GPIO OUT 2+
10
GPIO IN 1
11
Trigger IN
12
ISO GND