Argo POLIFEMO BRIZO 사용 설명서 - 페이지 5

{카테고리_이름} Argo POLIFEMO BRIZO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo POLIFEMO BRIZO 10 페이지. Misting fan

The appliance does not need to be installed.

When the product it's used for first time, tear off the tape stuck on the unit and take out the paper tube in the water tank.

Position the unit on a flat, stable surface and connect the power cord to a suitable power socket (220-240 V~/50HZ).

When you move the appliance, use the handle on the back do not tilt or shake the unit to prevent the water from

overflowing. Do not use this product in an area with high humidity, rich of dust or with a temperature exceeding 40° C.

This product can be used both as a fan, with 4 modes (Normal, Nature and Sleeping) and 4 fan speed options and as

nebulizer.

MISTING FUNCTION

In this case the rear tank should be filled with demineralized water, up to but not exceeding the maximum level as

indicated.

Through a high-frequency vibration (not audible and not harmful to people) the water under the tank is

nebulized and sucked into the tube up to the misting plate where it is emitted into the room.

There is no need to heat or to add any chemical agent. The refreshing action of water can give a sense of well-being

when the environment is dry. It's not possible to activate the misting function without water in the water tank. Do not fill the

water directly on water channel or in the mist outlet, do not block the mist outlet during operation.

When the water below the tank falls below the minimum level, the appliance emits a sound and the nebulizer switches off.

All the buttons on the control panel are touch-sensitive: a light touch is enough to select the

functions.

FAN ON/OFF: After putting through the power, touch the button Fan On/Off to turn on or turn off the fan.

MODE setting: Under unit on status, touch this button to change the sequence Normal -> Natural -> Sleeping with

corresponding indicator on.

- Normal: Fan speed is constant

- Natural: Fan speed will authomatically change, alternating periods of low, mediumg and high speed

- Sleeping: Fan speed will authomatically change, alternating periods of low, medium and high speed according to preset

program. The unit is defaulted to be turned off after 8 hours if any operation is performed.

SPEED: There are 4 ventilation speed: 1, 2, 3, 4. Under unit on status, touch with button to increase the fan speed from

1 (minimum speed) to 4 (maximum speed) with the corresponding indicator on. Touching again speed 4 it returns to

speed 1.

TIMER/PRESET:

TIMER: Under unit on status, touching button Timer/Preset on control panel or on remote control, will be possible to set

the timer off time in the sequence of 1 -> 2 -> 3 -> 4 -> 5 -> 6 -> 7 -> 8 -> cancel. The corresponding indicator will be on

on the panel.

PRESET: Under stand by status, touching the button Timer/Preset on the control panel or on the remote control will be

possible to set the number of hours after which the product will start working with the following sequence (expressed in

hours of operation) 1 -> 2 -> 3 -> 4 -> 5 -> 6 -> 7 -> 8 -> cancel. The indicator corresponding the selecyed sequence will

be on on the panel.

V 03/20

HOW TO USE THE APPLIANCE

CONTROL PANEL AND AVAILABLE FUNCIONS