DIGITEN DHTC-1011 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} DIGITEN DHTC-1011에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITEN DHTC-1011 8 페이지. Temperature and humidity controller

function.

Correct temperature = temperature before calibration + calibration

value (CA), the calibration value can be positive, negative, or 0.

Troubleshooting

The load doesn't work

1. The green indicator light is on, but the load does not work.

Please use a multimeter to measure the socket of the controller. If the

voltage is 100-240VAC, please check your load device. Otherwise,

please contact the DIGITEN Customer Service.

2. The green indicator light is on, but the load does not work.

When energized, the PV is exactly within the RV and SV, which meets

your requirements, so the load device doesn't need to be turned on at

this time.

Err Alarm

When the temperature sensor is short-circuited or disconnected, pull

out the sending plug of sensor from the controller, and then press the

plug firmly into the hole of the controller after cleaning the plug.

WARRANTY

The DIGITEN products are guaranteed to the original owner for one

year against defects in workmanship and materials. Please contact us:

www.digit-en.com/support

RESERVED