Cisco ASA 5506-X 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} Cisco ASA 5506-X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506-X 14 페이지. Threat defense reimage guide
Cisco ASA 5506-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지), 하드웨어 설치 매뉴얼 (26 페이지)
페이지 인쇄
Cisco Firepower Threat Defense for the ASA 5506-X Series Using Firepower Device Manager Quick Start Guide
Procedure
1.
Connect the GigabitEthernet 1/1 (outside) interface to your ISP/WAN modem or other outside device. By
default, the IP address is obtained using DHCP, but you can set a static address during initial configuration.
2.
Connect a local management workstation to GigabitEthernet 1/2 (or another of the inside bridge group
member interfaces).
3.
Configure the workstation to obtain an IP address using DHCP. The workstation gets an address on the
192.168.1.0/24 network.
Note:
You have a couple of other options for connecting the management workstation. You can also directly
connect it to the Management port. The workstation gets an address through DHCP on the 192.168.45.0/24
network. Another option is to leave your workstation attached to a switch, and attach that switch to one of the
inside ports such as GigabitEthernet1/2. However, you must ensure that no other device on the switch's
network is running a DHCP server, because it will conflict with the one running on the inside bridge group,
192.168.1.1.
Version 6.1
Figure 7
ASA 5506W-X (with Wi-Fi), 5506-X (without Wi-Fi) for Version 6.1.
GigabitEthernet 1/1
outside, DHCP from Modem
Status
wLAN
Power
Active
S
L
S
L S
Power
1
2
12VDC, 5A
GigabitEthernet 1/2
inside, 192.168.45.1
(Gateway)
WAN Modem
Internet
Management 1/1
192.168.45.45
S
L S
L S
L S
L S
L S
L
3
4
5
6
7
8
Layer 2 Switch
4. Deploy the Firepower Threat Defense in Your Network
GigabitEthernet 1/9 (internal)
wifi, Access Point (from DHCP)
192.168.10.2
L
GE MGMT
USB
RESET
CONSOLE
Management Computer
DHCP from inside:192.168.45.x
6
Wireless Clients
(from DHCP)
192.168.10.x