Cisco ASA 5506-X 마운트 및 연결 - 페이지 8

{카테고리_이름} Cisco ASA 5506-X에 대한 마운트 및 연결을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506-X 12 페이지. Threat defense reimage guide
Cisco ASA 5506-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지), 하드웨어 설치 매뉴얼 (26 페이지)

페이지 인쇄

Connect to a Console Terminal or PC

Management 1/1 interface (RJ-45)

b) (Optional) Console port – For use with the CLI. Connect a computer or terminal server using a serial console cable

to either the RJ-45 or Mini USB Type B port.

Only one console port can be active at a time. When a cable is plugged into the USB console port, the RJ-45 port

becomes inactive. Conversely, when the USB cable is removed from the Mini USB Type B port, the RJ-45 port

becomes active. See

console port.

c) Gigabit Ethernet ports – For the network interfaces; use standard RJ-45 Ethernet cables.

Step 2

Connect the power cord to the ASA, and plug the other end to your power source.

The ASA 5506-X, 5506W-X, and ASA 5506H-X do not have an on/off switch; the device powers on when

Note

you plug it into a power source.

Step 3

Check the Status LED on the ASA chassis.

When it is solid green, the ASA has passed power-on diagnostics.

Step 4

See the

Cisco ASA 5506-X Series Quick Start Guide

Your ASA ships with either ASA or Firepower Threat Defense software preinstalled. To reimage your device,

Note

see

Reimage the Cisco ASA or Firepower Threat Defense

Connect to a Console Terminal or PC

The serial ports provide administrative access to the ASA either with a console terminal or a PC. To configure

the ASA through the CLI, you must establish a connection between the ASA console port and either a terminal

or a PC.

This section describes how to connect to a console terminal or a PC, and contains the following topics:

Connect to the Console Port with Microsoft Windows

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB

serial port on the ASA, otherwise the connection fails.

To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.

Note

Disconnect the ASA console terminal before uninstalling the driver.

Step 1

Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your ASA model

from the Cisco

Download Software

Step 2

Install the driver.

Mount and Connect

Connect to a Console Terminal or PC, on page 8

site, USB Console Software category.

for specific instructions for connecting the

to continue setting up your ASA.

Device.

Mount and Connect