Cisco ASA 5506-X 하드웨어 설치 매뉴얼 - 페이지 10

{카테고리_이름} Cisco ASA 5506-X에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506-X 26 페이지. Threat defense reimage guide
Cisco ASA 5506-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (14 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

Internal and External Flash Storage

(CLI) to configure your ASA through either serial console port by using a terminal server or a terminal

emulation program on a computer.

See

Connect to a Console Terminal or PC, on page 19

RJ-45 Port

Mini USB Type B Port

For Windows operating systems, you must install a Cisco Windows USB Console Driver on any PC

Note

connected to the console port before using the USB console port. See

Microsoft Windows, on page 19

Internal and External Flash Storage

The ASA contains one internal USB flash drive, and a standard USB Type A port that you can use to attach

an external device. The USB port can provide output power of 5 volts, up to a maximum of 500 mA (5 USB

power units).

Internal USB Device

External USB Drive (Optional)

FAT-32 File System

Cisco ASA 5506-X Hardware Installation Guide

The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The RJ-45 console

port does not support a remote dial-in modem. You can use a standard management cable (Cisco part

number 72-3383-01) to convert the RJ45-to-DB9 connection if necessary.

The Mini USB Type B port lets you connect to a USB port on an external computer. For Linux and

Macintosh systems, no special driver is required. For Windows systems, you must download and install

a USB driver (available on software.cisco.com). You can plug and unplug the USB cable from the

console port without affecting Windows HyperTerminal operations. We recommend shielded USB

cables with properly terminated shields. Baud rates for the USB console port are 1200, 2400, 4800,

9600, 19200, 38400, 57600, and 115200 bps.

An embedded eUSB device is used as the internal flash; it is identified as disk0.

You can use the external Type A USB port to attach a data-storage device. The external USB drive

identifier is disk1. When the ASA is powered on, a connected USB drive is mounted as disk1 and is

available for you to use. Additionally, the file-system commands that are available to disk0 are also

available to disk1, including copy, format, delete, mkdir, pwd, cd, and so on.

If you insert a USB drive with more than one partition, only the first partition is mounted.

The ASA only supports FAT-32-formatted file systems for the internal eUSB and external USB drives.

If you insert an external USB drive that is not in FAT-32 format, the system mounting process fails,

and you receive an error message. You can enter the command format disk1: to format the partition

to FAT-32 and mount the partition to disk1 again; however, data might be lost.

for the procedure to install a console terminal.

for information on installing the driver.

About the ASA 5506-X

Connect to the Console Port with

Online Only