Sony LBTZX66i - 560 Watts Muteki Hi-Fi Audio Mini Component System 사용 설명서 - 페이지 20
{카테고리_이름} Sony LBTZX66i - 560 Watts Muteki Hi-Fi Audio Mini Component System에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony LBTZX66i - 560 Watts Muteki Hi-Fi Audio Mini Component System 44 페이지. Sony mini hi-fi component system operating instructions
페이지 인쇄
To set CD power on
Repeat the procedure above and "CD
POWER ON" appears in the display.
Notes
• When "CD POWER OFF" is selected, disc
access time is increased.
• You cannot change the CD power manage
setting in Power Saving Mode (page 27).
To change the AM tuning interval
The factory setting for AM tuning interval
is 10 kHz.
Use the buttons on the unit for the
operation.
1
Press TUNER/BAND repeatedly to
select AM band.
2
Press "/1 to turn off the system.
3
When demonstration appears, hold
down TUNING MODE and then
press "/1.
The system turn on automatically.
"AM 9K STEP" or "AM 10K STEP"
appears in the display.
When you change the interval, all the AM
preset stations are erased.
Tip
To improve broadcast reception, adjust the
supplied antennas, or connect an external
antenna.
To reduce static noise on a weak FM
stereo station
Press FM MODE repeatedly until
"MONO" lights up in the display.
There will be no stereo effect, but the
reception will improve.
20
US
Playing the iPod
You can listen to audio contents stored in
the iPod on this system.
1
Press iPod.
2
Place the iPod.
3
Press NX (or N on the
remote) to start playback.
4
Turn VOLUME +/– (or press
VOLUME +/– on the remote) to
adjust the volume.
Notes
• When you connect an iPod to the unit, the
iPod is automatically turned on if the system
is turned on.
• When placing or removing the iPod, handle
the iPod in the same angle as that of the iPod
connector on the unit and do not twist or sway
the iPod to prevent connector damage.
• Do not carry the unit with an iPod set on the
connector. Doing so may cause a malfunction.
• When placing or removing the iPod, brace the
unit with one hand and take care not to press
the controls of the iPod by mistake.
• Before disconnecting the iPod, pause
playback.
• Depending on the connected iPod, you may
not able to use m or M while playing
video. In this case, you can fast rewind or fast
forward by holding down . or >.
• To change the volume level, use
VOLUME +/–. The volume level does not
change even if adjusted on the iPod.
• This iPod connector is designed for iPod only.
You cannot connect any other portable audio
players.