Sony MEX-BT3100P 사용 설명서 - 페이지 33
{카테고리_이름} Sony MEX-BT3100P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MEX-BT3100P 50 페이지. Bluetooth audio system
Sony MEX-BT3100P에 대해서도 마찬가지입니다: 사양 (6 페이지)
페이지 인쇄
G:\#sagyou\0613\4427433111\4427433111MEXBT3100PUC\01GB-
MEXBT3100PUC\040CD.fm
000COV.book Page 33 Wednesday, June 13, 2012 9:30 PM
6
Rotate the control dial to select the
subwoofer position from "NEAR,"
"NORMAL" or "FAR," then press it.
7
Press
(BACK) to return to the
previous display.
To cancel listening position, select "OFF" in
step 4.
Adjusting the listening
position
You can fine-tune the listening position
setting.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until
"POSITION" appears, then press it.
3
Rotate the control dial until "ADJ
POSITION" appears, then press it.
4
Rotate the control dial to adjust the
listening position, then press it.
Adjustable range: "+3" – "CENTER" –
"–3."
5
Press
(BACK) to return to the
previous display.
DM+ Advanced
DM+ Advanced improves digitally
compressed sound by restoring high
frequencies lost in the compression process.
1
During playback, press , rotate
the control dial until "SOUND"
appears, then press it.
2
Rotate the control dial until "DM+"
appears, then press it.
3
Rotate the control dial to select "ON,"
then press it.
4
Press
(BACK) to return to the
previous display.
Tip
The DM+ setting can be memorized for each
source other than the tuner.
Using rear speakers as
subwoofer — Rear Bass
Enhancer
Rear Bass Enhancer enhances the bass
sound by applying a low pass filter setting
(page 35) to the rear speakers. This function
allows the rear speakers to work as a
subwoofer if one is not connected.
1
During reception/playback, press
, rotate the control dial until
"SOUND" appears, then press it.
2
Rotate the control dial until "RB ENH"
appears, then press it.
3
Rotate the control dial until "RBE
MODE" appears, then press it.
4
Rotate the control dial to select from
"1," "2" or "3," then press it.
5
Press
(BACK) to return to the
previous display.
Using a subwoofer without a
power amplifier —
Subwoofer Direct Connection
You can use the subwoofer without a power
amplifier when it is connected to the rear
speaker cord.
Note
Be sure to connect a 4 - 8 ohm subwoofer to
either of the rear speaker cords. Do not connect a
speaker to the other rear speaker cord.
masterpage:Right
33
MEX-BT3100P
4-427-433-11(1)