Cisco ASA 5506W-X 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Cisco ASA 5506W-X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5506W-X 14 페이지. Threat defense reimage guide
Cisco ASA 5506W-X에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (10 페이지), 구성 매뉴얼 (13 페이지), 간편한 설정 매뉴얼 (11 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (12 페이지), 설치 매뉴얼 (46 페이지), 섀시 마운트 (10 페이지)

페이지 인쇄

Cisco Firepower Threat Defense for the ASA 5506-X Series Using Firepower Device Manager Quick Start Guide

Procedure

Connect the GigabitEthernet 1/1 (outside) interface to your ISP/WAN modem or other outside device. By

default, the IP address is obtained using DHCP, but you can set a static address during initial configuration.

Connect a local management workstation to GigabitEthernet 1/2 (or another of the inside bridge group

member interfaces).

Configure the workstation to obtain an IP address using DHCP. The workstation gets an address on the

192.168.1.0/24 network.

Note:

You have a couple of other options for connecting the management workstation. You can also directly

connect it to the Management port. The workstation gets an address through DHCP on the 192.168.45.0/24

network. Another option is to leave your workstation attached to a switch, and attach that switch to one of the

inside ports such as GigabitEthernet1/2. However, you must ensure that no other device on the switch's

network is running a DHCP server, because it will conflict with the one running on the inside bridge group,

192.168.1.1.

Version 6.1

Figure 7

ASA 5506W-X (with Wi-Fi), 5506-X (without Wi-Fi) for Version 6.1.

GigabitEthernet 1/1

outside, DHCP from Modem

Status

wLAN

Power

Active

L S

Power

12VDC, 5A

GigabitEthernet 1/2

inside, 192.168.45.1

(Gateway)

WAN Modem

Internet

Management 1/1

192.168.45.45

L S

Layer 2 Switch

4. Deploy the Firepower Threat Defense in Your Network

GigabitEthernet 1/9 (internal)

wifi, Access Point (from DHCP)

192.168.10.2

GE MGMT

USB

RESET

CONSOLE

Management Computer

DHCP from inside:192.168.45.x

Wireless Clients

(from DHCP)

192.168.10.x